Adventures in 3D Printing #3: Panic Button

For reasons I can't quite explain, I fancied making a large, red, network-enabled "Panic Button". The idea is that if anything bad happens on the internets the button will flash red and I can then press the button to restore peace and harmony to cyberspace.  Or something. 

I'm going to pop a Photon device in there and then hook it up to If This Then That so that I can get it to signal simple messages. I've designed the box (curved corners and bevelled edges) and printed one out in yellow. I'm going to add some black tape to make it look properly panicky.